removed unwanted data

BMP085test/BMP085test.ino

@@ -1,66 +0,0 @@
-#include <Wire.h>
-#include <Adafruit_BMP085.h>
-
-/*************************************************** 
-  This is an example for the BMP085 Barometric Pressure & Temp Sensor
-
-  Designed specifically to work with the Adafruit BMP085 Breakout 
-  ----> https://www.adafruit.com/products/391
-
-  These displays use I2C to communicate, 2 pins are required to  
-  interface
-  Adafruit invests time and resources providing this open source code, 
-  please support Adafruit and open-source hardware by purchasing 
-  products from Adafruit!
-
-  Written by Limor Fried/Ladyada for Adafruit Industries.  
-  BSD license, all text above must be included in any redistribution
- ****************************************************/
-
-// Connect VCC of the BMP085 sensor to 3.3V (NOT 5.0V!)
-// Connect GND to Ground
-// Connect SCL to i2c clock - on '168/'328 Arduino Uno/Duemilanove/etc thats Analog 5
-// Connect SDA to i2c data - on '168/'328 Arduino Uno/Duemilanove/etc thats Analog 4
-// EOC is not used, it signifies an end of conversion
-// XCLR is a reset pin, also not used here
-
-Adafruit_BMP085 bmp;
-  
-void setup() {
-  Serial.begin(9600);
-  if (!bmp.begin()) {
-	Serial.println("Could not find a valid BMP085 sensor, check wiring!");
-	while (1) {}
-  }
-}
-  
-void loop() {
-    Serial.print("Temperature = ");
-    Serial.print(bmp.readTemperature());
-    Serial.println(" *C");
-    
-    Serial.print("Pressure = ");
-    Serial.print(bmp.readPressure());
-    Serial.println(" Pa");
-    
-    // Calculate altitude assuming 'standard' barometric
-    // pressure of 1013.25 millibar = 101325 Pascal
-    Serial.print("Altitude = ");
-    Serial.print(bmp.readAltitude());
-    Serial.println(" meters");
-
-    Serial.print("Pressure at sealevel (calculated) = ");
-    Serial.print(bmp.readSealevelPressure());
-    Serial.println(" Pa");
-
-  // you can get a more precise measurement of altitude
-  // if you know the current sea level pressure which will
-  // vary with weather and such. If it is 1015 millibars
-  // that is equal to 101500 Pascals.
-    Serial.print("Real altitude = ");
-    Serial.print(bmp.readAltitude(101500));
-    Serial.println(" meters");
-    
-    Serial.println();
-    delay(500);
-}

src/test.py

@@ -1,4 +0,0 @@
-hallo = input("Zahl1:")
-b = input("Zahl2:")
-
-print(hallo+b)